A: Per the description, This is For use on iron, steel, aluminum and properly primed galvanized metal, so it depends on the kind of metal it's made out of.

A: For additional product support, please contact info@majicpaints.com.

A: No, that option is not available.

A: For the best results you will need to prep the area before painting.

A: Majic Tractor, Truck & Implement Enamels are very hard drying, rust inhibitive oil/alkyd coatings that demonstrate excellent adhesion, plus abrasion and impact resistance, and heat resistance to approximately 250° F. The surface must be clean, dry and free of all foreign matter (including grease, oil, loose or flaking rust & paint, etc.) prior to painting. Prime all exposed steel surfaces with either Sandable Gray, or Red Oxide Primer and allow to dry thoroughly before applying 2 finish coats of Ford Red, #8-2954… This system, when applied according to package directions will Please read and follow package directions carefully – with special attention to the recommended applied thickness (2.5 mils wet), and the allowable recoat times (24 hours minimum) – Too heavy an application, and/or re-coating too soon will result in a film that won’t dry “hard” for several days…or longer.

A: This product can be used on iron, steel, aluminum and primed galvanized metal.

A: Majic Tractor, Truck & Implement Coatings are high solids, hard-drying, corrosion resistant, oil/alkyd coatings that exhibit exceptional adhesion and protection to the surface being painted. When applied in accordance to package directions (specifically at the recommended applied thickness of 2.5 mils wet, and at moderate surface & temperatures with relative humidity at, or less than, 50%), the “tack-free” time is usually between 4-6 hours, and the “allowable” recoat time is 24 hours (thin application / 24 hours between coats). Too heavy an application, and/or re-coating too soon will result in a film that won’t dry “hard” for several days… or longer. We do recommend light sanding between coats with 350 grit paper, or a fine Scotch Brite pad. For spray application, we recommend the product be thinned 8:1 with Majic Reducer*, #8-0750, (8 parts Majic T&I Enamel to 1 part Majic Reducer). Proper reduction is necessary for a fine atomization of product, and aids both in the flow & leveling of the applied film, and in controlling, and maintaining, the recommended applied thickness of the film. *Majic Reducer is a proprietary blend of “exempt” solvents, that is a perfect mix with Majic T&I Primers & Enamels. Majic Reducer adds 0 VOC’s to the mix, and allows the host product to remain VOC compliant. For cleaning spills, tools & equipment, use Mineral Spirits, or Paint Thinner.

A: The solvent structure of Majic Clear Coat, while similar to that of the Tractor & Implement Enamels, is of greater strength and concentration than the finish enamels. As a result, and to minimize the risk of a reaction from the stronger solvents, the final coat of Enamel must cure – a minimum of 10-14 days before applying Majic Clear Coat. Applying Clear Coat before finish enamel has cured properly may result in wrinkling of the one, or both, applied films.