US Stove Barrel Camp Multifuel Stove Kit

Here is the process I used to prep the barrel: First, I cut out all openings with a reciprocating metal saw using the door and flue collar as templates. I used a scribe to mark the openings and bolt holes. Before installing the kit hardware, I cleaned the barrel well with a wire brush, then built a small bon fire around the barrel. I burned off any coating or film, both inside and out. I did this step far away from buildings, people and livestock as there was a strong odor. I also wore a protective mask and kept a garden hose nearby. (Observe your local fire codes.) I continued the fire until the barrel appeared charred and a flat black color, and I was sure that all coating material has been burned off. I had to rotate it during the burning process using a long handle or rod so that all sides, top and bottom were burned clean. I then removed the barrel from the fire and allowed it to cool for an hour or so. Next, I applied a spray coat of high-heat ("1200-degree F") barbeque grill paint to the exterior of the barrel and let it dry according to the paint manufacturer's instructions. Finally, I installed the barrel stove hardware kit. I chocked all cracks with 1/2-inch diameter fiberglass roping (available at TSC) around the door and flue so there is no smoke leakage. While still outdoors, I attached a 4-foot length of stove pipe with damper installed onto the barrel and burned a small amount of paper and clean, dry kindling to test for smoke leaks and proper draft. Once the stove performed satisfactorily, according to kit manufacturer's specifications, I installed it in my hunting cabin.

Very disappointed! lt only worked a couple of minutes with a blue plastic barrel.