A: Hi Neighbor! No, the Majic 1 gal. Gray Primer All Purpose Enamel Shop Primer is not specifically designed for vehicles.

A: Yes, once it has dried.

A: Majic All Purpose Gray Shop Primer is a good quality, hard-drying oil/alkyd coating that provides tight adhesion, good corrosion resistance, and very good hold out of sheened finishes. When applied in strict accordance to the printed directions (with special attention to the recommended applied thickness (not to exceed 3.0 mils wet), and the allowable re-coat time (minimum 24 hours) – this material should be dry enough to sand the primer at 24 hours with 220 grit paper (or finer) – please understand that if the product is applied too heavily, and/or re-coated too soon, the film will not dry “hard” for possibly several days…or longer. Re-coat, and sanding, restrictions may need to be adjusted based on temperature and humidity – Do not thin product, and avoid painting in direct sunlight, or when rain is expected within 8 hours of painting.

A: This is the vendor's response: Majic AP Enamel Shop Primer Gray is a utility grade, rust-inhibitive oil base primer designed, primarily, for use on clean, dry and properly prepared ferrous metal surfaces. Any rust should be removed by wire brushing, grinding, or blasting before priming, all bare metal needs priming, and new sheet metal should be sanded, or etched, for a better mechanical adhesion with AP Shop Primer. Apply AP Shop Primer by brush, roller or spray, in strict accordance to package directions - with special attention given to recommended applied thickness (thin coats @ 3-4 mils wet) & allowable recoat times (minimum 24 hours). Air, and surface, temps should be above 55° F. , with relative humidity at less than 60% (cooler temps and/or higher humidity will slow drying and cure of oil base products). Do NOT thin product for application, and the use of a catalyst hardener is NOT recommended with Majic All Purpose Primers or Enamels. Once dry, product may be topcoated (finished) with either Majic All Purpose Enamel, or Majic Tractor, Truck & Implement Enamels, again in accordance to package directions. For best results, 2 coats of finish are recommended over primer – and allow ample curing before putting into use.

A: Per the manufacturer: Generally, Majic All Purpose Shop Primer requires no reduction for spray (airless or conventional), but if reduction is necessary, or desired, use only Majic Reducer, TSC SKU: 1177119, up to approximately 5% (about 6 ounces per gallon). Do not use a Catalyst Hardener with the All Purpose line of Primers or Finish Enamels. For proper drying, and cure, apply product in thin coats (not to exceed 4.0 mils wet), and allow 24 hours between coats, or before applying finish.

A: Please call 1-800-451-8346 for MSDS information.

A: Majic All Purpose Enamel Shop Primer Gray is an all purpose, utility enamel. It is fine for use on wood (and other) surfaces, and may be used as a prime coat for oil base, or latex topcoats. The limitations for this product are as follows: Majic AP Primer is not designed for use on wood decks, nor wood surfaces subject to traffic (foot or vehicular). Majic AP Primer, and Enamels, are “ready-to-apply” coatings – Do not thin, and DO NOT MIX WITH CATALYST-HARDENER. Please follow instructions carefully regarding the recommended applied thickness (3.0 mils wet), and allowable re-coat times (minimum 24 hours).