KBS Coatings BlackTop, Aerosol, OEM Satin Black

KBS BlackTop in OEM Satin Black is a single stage, moisture cured urethane topcoat built for equipment that lives outside. It goes on direct to bare metal with no primer required, and it also bonds over RustSeal, epoxy primer, or existing paint, making it the go to black for tractor and implement frames, loader arms, gooseneck and utility trailers, truck chassis, mower decks, bush hogs, gates, and wrought iron. BlackTop is permanently UV stable, so it will not chalk or fade the way ordinary black enamel does after a season in the sun. It is rock hard yet flexible enough to expand and contract with the metal, and it has been salt spray tested to 1000 hours on its own and 2000 hours when applied over RustSeal, which matters on anything that sees road salt, fertilizer, or manure. This is OEM Satin Black, the factory correct low sheen look at 55 to 65 percent gloss. Spray it on straight from the can, no gun and no cleanup. No hardener and no clear coat needed. This 12 oz aerosol covers about 38 sq ft at 2 mils and is sized for touch ups, hard to reach spots, and small parts. Proudly made in the USA.Apply BlackTop to a clean, dry surface. Use KBS Klean to remove dirt and grease, and avoid solvent based cleaners that leave a residue. For the best rust protection, seal bare metal with RustSeal first, then topcoat with BlackTop. On other painted surfaces, scuff lightly with 320 grit, then clean and dry. Spray at 60 to 78 degrees Fahrenheit in 30 to 70 percent humidity. Shake the can at least one minute after the mixing ball rattles, then about 10 seconds every 1 to 2 minutes during use. Hold the can 6 to 8 inches from the surface and apply thin, covering coats with overlapping strokes rather than one heavy pass. Recoat once the previous coat is dry to the touch and leaves no fingerprint, and before 24 hours. Past 24 hours, scuff with 320 grit first. Full cure is 48 hours. After use, invert the can and spray 4 seconds to clear the valve. Always work in a well ventilated area and wear protective gloves and eye wear.