A: To install a CountyLine Category 2 Narrow Lift Arm Ball for Ford Models, you do not need any special tools. Many Ford tractors (such as the 3000, 4000, and 5000 series) feature a quick-change socket design with a side-loading slot that allows you to swap out just the ball manually. Step-by-Step Installation 1.Remove the Old Ball: Turn the existing lift arm ball 90 degrees inside the socket until the pin-hole axis is completely vertical (perpendicular to the ground). Align the flat edges or narrow profile of the ball with the matching cutout slot on the side of the lift arm housing, and pull it out by hand. 2.Clean the Socket: Use a wire brush and penetrating oil to clear out any dirt, rust, or old debris inside the lift arm socket 3.Insert the New Ball: Position the new CountyLine lift arm ball at a 90-degree angle so that its narrow profile aligns perfectly with the cutout entry slot on the lift arm. Push the ball into the housing socket 4.Lock It in Place: Rotate the ball 90 degrees back into its standard operating position so that the pin-hole faces horizontally (parallel to the ground). This effectively locks the ball inside the forged socket so it cannot slip out during use 5.Lubricate: Apply a thin layer of grease or hydraulic fluid to ensure smooth rotation within the hitch assembly during operation Note: If your specific Ford lift arm uses a small retaining spring clip or roll pin instead of a purely slotted socket, you will need to pop the clip out with a flathead screwdriver before rotating the ball, and snap a new clip into place once the new ball is seated

A: The category 2 lift arm ball is designed for Ford models and compatible with compact tractors. The measurements for this product is listed below, please check if it will fit your unit. Length: 1-7/8in. Width: 1-7/8in. Height: 1-1/2in. Pin Hole Size: 1-1/8in. Hitch Category: 2

A: The Ford 4600 tractor should be a CAT1. None the less, we show all of our top link & lift arm replacement balls as being discontinued. Both of the lift arm balls you show on your web page for Ford tractors should work.

A: The measurements for this product is listed below, please check if it will fit your unit. Length: 1-7/8in. Width: 1-7/8in. Height: 1-1/2in. Pin Hole Size: 1-1/8in. Hitch Category: 2