This product works great with my side by side to spray small pastures with uneven terrain. I use it for spraying liquid nitrogen, 2-4-D, and Crossbow with a 26 gallon tank sprayer.

WorkHorse seems to have made some revisions to the design, which I assume were meant for the better. They switched to a standard nozzle body clamp, which is fine. I like standardized parts. However, the standard nozzle body clamp lowers the nozzle body from the top of the boom tube to the center. This creates a clearance issue for the nozzles closest to the boom hinge. (See attached Pic) I called support about it, and while the representative was polite and helpful, I wasn't overly thrilled with the final resolution. The suggestion was to move those two nozzles in away from the hinges a couple of inches. This would resolve the issue, but we are now fudging the 20" nozzle spacing. It isn't a huge deal, but enough to bother me. A few other changes. The lower receiver bracket now calls for 2 bolts versus using a pin that can be adjusted without tools. This is probably for stability, and I can live with that. The hose and nozzle bodies are all pre-assembled, but the hose clamps are not the standard screw type. They are probably good quality, but again, loses the serviceability. The hose coming from the pump also goes directly into the center nozzle body instead of T'd inline. I had intentions of putting shut off valves inline, which just slightly changes what nozzles I would be able to turn off with the added valves. Attached is an updated photo of the product that shows all off these changes. I will keep the boom, but will probably replumb it to my liking.