KBS Coatings KBS Top Coater, Camo, 4 pk.

The KBS Top Coater Camo 4 Pack puts a full camo pattern in one box: one 12 oz aerosol each of Flat Black Camo, Green Camo, Desert Tan Camo, and Brown Camo. Use it on hunting blinds, deer stands, feeders, trailers, boats, ATVs, and gun safes. KBS Top Coater Aerosol is a high solids, UV stable spray paint that bonds direct to bare steel and aluminum, does not run or sag, and gives at least twice the coverage of conventional spray paint. The flat finish will not chalk or fade in the sun. Together the four cans cover up to 100 sq ft in a full camo pattern, allowing for the overspray of building the pattern.Apply to clean, dry surfaces. For the best rust protection, seal rusted metal with RustSeal first. Over freshly painted RustSeal 3 to 8 hours old, apply KBS Top Coater directly with no other prep. For all other surfaces, lightly sand or scuff with 320 grit, then clean with KBS Klean, rinse, and dry. Avoid solvent based cleaners, which leave a residue that hurts adhesion. Shake the can for at least one minute after the mixing ball rattles, and shake for about 10 seconds every 1 to 2 minutes while spraying. Spray in moderate to dry conditions, 70 percent humidity or lower. Use smooth, overlapping strokes and apply thin coats; if it runs or sags, the coat is too heavy or the can is too close. Apply one or two thin covering coats, or two to three for marine and industrial use. Recoat once the previous coat is dry to touch, typically 1 to 2 hours, and within 24 hours. To clear the tip, turn the can upside down and spray for 3 seconds. Clean overspray with KBS number 1 Thinner or lacquer thinner.