Black Jack 3.6 qt. Silver-Seal 300 Fibered Aluminum Roof Coating
$24.99
Black Jack 3.6 qt. Silver-Seal 300 Fibered Aluminum Roof Coating
Black Jack 3.6 qt. Silver-Seal 300 Fibered Aluminum Roof Coating
Item # 138488399
Notice:
This Item cannot be shipped to CA.Get everything you need
Neighbor’s Club Members earn points with purchases.
Shopping at
Grassland (franklin) TN
Delivery to
Free standard delivery on online footwear & Clothing purchases of $49 and over.
Notice:
This Item cannot be shipped to CA.Get everything you need
Neighbor’s Club Members earn points with purchases.
The Black Jack Silver-Seal 300 Fibered Aluminum Roof Coating is a liquid applied coating that forms a reflective and protective finish to roofs. This blend of asphalt and aluminum forms a bright silver finish that reflects heat and UV rays. This roof sealant will seal and waterproof a variety of roof and outside wall surfaces. It protects, insulates, decorates and preserves built-up asphalt roofs, composition roofs, silos, metal roofs, siding, and water towers. The roof coating sealant may also be used on cinder blocks as a sidewall coating. Do not use Silver-Seal on shingle roofs, or over rubber membranes, EPDM roofing systems, or elastomeric type coatings.
- Silver-Seal provides solar protection and reflects the sun's rays
- Sealant helps save energy and reduces interior temperatures
- Roof coating preserves and waterproofs a variety of roof and outside wall surfaces
- Brilliant aluminized finish
- Gardner-Gibson warrants product to be free of material defects for a period of 3 years, the "Warranty Period", from the date of purchase. Product must be applied in accordance with the proper application procedures, and for the intended use as stated on the label. Proper preparation and drying conditions must be observed to achieve correct results. Should a product not perform as stated, Gardner-Gibson shall, within its sole discretion and upon receipt of purchaser's timely written notice within the Warranty Period, provide replacement product to repair the affected area or prorate a portion of the purchase price of the defective product based on the claim period. This limited warranty does not cover labor or installation costs, consequential damages or incidental damages. Under no circumstances will the company be liable for any amount in excess of the product purchase price. Contact company to request a refund with purchase receipt. There are no warranties which extend beyond the description on the face hereof. THIS LIMITED WARRANTY IS THE SOLE WARRANTY PROVIDED BY GARDNER-GIBSON TO THE PURCHASER. THERE IS NO IMPLIED WARRANTY of MERCHANTABILITY OR IMPLIED WARRANTY of FITNESS for A PARTICULAR PURPOSE PROVIDED with THIS PRODUCT.
| Brand | Black Jack |
|---|---|
| Country of Origin | Made in USA |
| Container Size | 3.6 qt. |
| Coverage Area | Over metal: 1 gal. per 75 sq. ft., on Built-up roofing: 1 gal. per 50 sq. ft. Smooth surfaces will have higher coverage rates |
| Cure Time | 48 hr. |
| Dry to Touch | 24 hours |
| Features | Build-Up Roofing, Metal Roofing, Modified Bitumen Roofing |
| Longevity | Gardner-Gibson warrants product to be free of material defects for a period of 3 years, the "Warranty Period", from the date of purchase. |
| Package Quantity | 1 |
| Primary Color | Gray |
| Product Form | Coating |
| Product Height | 7.75 in. |
| Product Length | 6.75 in. |
| Product Weight | 9 lb. |
| Product Width | 6.75 in. |
| Manufacturer Part Number | 5175-A-34 |
Have a question?
Start typing your question and we'll check if it was already asked and answered.
1 - 9 of 9 Questions
Newest questions
Q: Can this product be applied by an airless sprayer, if so what is the recommended required PSI? I would be applying it on metal siding.
a year ago1 Answer
- A: Hi Neighbor! Apply it evenly with a brush or roller, overlapping strokes and avoiding excessive build-up.a year agoHelpful?
Q: Can this product be used on a vinyl storage shed roof?
3 years ago1 Answer
- A: Do not use Silver-Seal on shingle roofs, or over rubber membranes, EPDM roofing systems, or elastomeric type coatings3 years agoHelpful?
Q: Should a metal roof be dry of xew before applying
4 years ago1 Answer
- A: Yes.4 years agoHelpful?
Q: How much do you need to cover a 16×60 mobile home roof
4 years ago1 Answer
- A: Over metal: 1 gal per 75 square feet; on Built-up roofing: 1 gal per 50 sq. ft. So you will need anywhere from 12.8-19.2 gal. Smooth surfaces will have higher coverage rates.4 years agoHelpful?
Q: Why can't you use this product on a regular rv roof?
4 years ago1 Answer
- A: This blend of asphalt and aluminum forms a bright silver finish that reflects heat and UV rays. This product is not recommended for use on wood, asphalt shingles or roofs with slopes less than 1% (or 1/8” per ft.). Standing water dulls aluminum, and may cause adhesion failure between the coating and substrate. Majority of RV’s have flat roofs with ponding water issues when parked. We don’t know what the roof is made of. Some RV’s have rubber roofs and you would never use SILVER-SEAL 300 on a rubber roof. Please recommend BLACK JACK® ETERNA-KOTE® SILICONE ROOF COATING, this product is formulated for flat rubber roofs and basically any substrate.4 years agoHelpful?
Q: Can this be used on a rv roof
4 years ago1 Answer
- A: If the RV has a metal roof, then yes, it can be used.4 years agoHelpful?
Q: Can I use this on flare 3/4 plywood?
5 years ago1 Answer
- A: Yes.5 years agoHelpful?
Q: Since this is a blend of asphalt and aluminum, will this act as a barrier to RF signals, i.e. similar to a metallic radiant barrier? Would the coating be conductive after it is dry?
5 years ago1 Answer
- A: The dried coating typically forms an aluminum oxide layer depending on multiple factors. We have not tested the conductivity levels or resistance to radio frequency signals.5 years agoHelpful?
Q: Do you have to put a primer down first on a metal roof? and does this come in different colors?
5 years ago1 Answer
- A: If this product is used on a metal roof, we recommend that any rusted areas be brushed with a wire brush and the area primed with a standard metal roof primer prior to applying the coating. Additional information regarding the product and the application of it are on the attached Technical Data Sheet. The product is not produced in any other colors.5 years agoHelpful?
Q&As
Have a question?
Start typing your question and we'll check if it was already asked and answered.
1 - 9 of 9 Questions
Newest questions
Q: Can this product be applied by an airless sprayer, if so what is the recommended required PSI? I would be applying it on metal siding.
a year ago1 Answer
- A: Hi Neighbor! Apply it evenly with a brush or roller, overlapping strokes and avoiding excessive build-up.a year agoHelpful?
Q: Can this product be used on a vinyl storage shed roof?
3 years ago1 Answer
- A: Do not use Silver-Seal on shingle roofs, or over rubber membranes, EPDM roofing systems, or elastomeric type coatings3 years agoHelpful?
Q: Should a metal roof be dry of xew before applying
4 years ago1 Answer
- A: Yes.4 years agoHelpful?
Q: How much do you need to cover a 16×60 mobile home roof
4 years ago1 Answer
- A: Over metal: 1 gal per 75 square feet; on Built-up roofing: 1 gal per 50 sq. ft. So you will need anywhere from 12.8-19.2 gal. Smooth surfaces will have higher coverage rates.4 years agoHelpful?
Q: Why can't you use this product on a regular rv roof?
4 years ago1 Answer
- A: This blend of asphalt and aluminum forms a bright silver finish that reflects heat and UV rays. This product is not recommended for use on wood, asphalt shingles or roofs with slopes less than 1% (or 1/8” per ft.). Standing water dulls aluminum, and may cause adhesion failure between the coating and substrate. Majority of RV’s have flat roofs with ponding water issues when parked. We don’t know what the roof is made of. Some RV’s have rubber roofs and you would never use SILVER-SEAL 300 on a rubber roof. Please recommend BLACK JACK® ETERNA-KOTE® SILICONE ROOF COATING, this product is formulated for flat rubber roofs and basically any substrate.4 years agoHelpful?
Q: Can this be used on a rv roof
4 years ago1 Answer
- A: If the RV has a metal roof, then yes, it can be used.4 years agoHelpful?
Q: Can I use this on flare 3/4 plywood?
5 years ago1 Answer
- A: Yes.5 years agoHelpful?
Q: Since this is a blend of asphalt and aluminum, will this act as a barrier to RF signals, i.e. similar to a metallic radiant barrier? Would the coating be conductive after it is dry?
5 years ago1 Answer
- A: The dried coating typically forms an aluminum oxide layer depending on multiple factors. We have not tested the conductivity levels or resistance to radio frequency signals.5 years agoHelpful?
Q: Do you have to put a primer down first on a metal roof? and does this come in different colors?
5 years ago1 Answer
- A: If this product is used on a metal roof, we recommend that any rusted areas be brushed with a wire brush and the area primed with a standard metal roof primer prior to applying the coating. Additional information regarding the product and the application of it are on the attached Technical Data Sheet. The product is not produced in any other colors.5 years agoHelpful?
Similar Items
-
-
-
Top Rated
-
-
-
-
-
-
-
-
-
Items You May Like
-
-
Top Rated
-
Top Rated
-
-
-
-
-
-
-
-
-
Customers Also Bought
-
Top Rated
-
-
-
-
Top Rated
-
-
-
-
-
-
-
Reviews
- measuring
- purchase
1 to 3 of 3 Reviews .
1 – 3 of 3 Reviews
Most Recent
Reviews 2
2 out of 5 stars.
UNSATISFIED
a year ago
Not enough silver color to be called silver seal.
I put two coats and still only minor silver.
Two stars because it did seal.
SweepstakesYes
No, I do not recommend this product.
Lexington, va 24450
Review 1
1 out of 5 stars.
Missing products
2 years ago
I ordered my products two weeks ago they were supposed to be delivered in 24 hours I still have not gotten my items
Reviews 4
5 out of 5 stars.
Measure carefully about 7gal for 1000ft Linear 2sd
3 years ago
Best use a 7” pole brush on a 5 or 6 ft pole
Yes, I recommend this product.