GEARWRENCH 15 pc. SAE Ratcheting Tap and Die Set

This is absolutely a life saver product. I had snapped a pull valve angle of at the threads and mated it pretty good. I was able to take this and tap it back to being able to screw a new handle in. Completely saved me. A tool everyone should have in their toolbox!

This is an awesome tap and die set. The tap holder holds the taps tight and square. The taps start into the material easily and leave perfect threads. The dies cut perfectly and don’t leave burrs. The ratcheting T wrench action is smooth and easy to use.

the taps are very nice and comes with an extension for a deeper reach. It cane in handy when I was chasing down thread holes in my trunk doing shocks and struts. The teeth are clean and shows no real signs of wear with moderate usage. Was also using this on an aluminum boat to clean up some threads and it did so wonderfully

This is an awesome thread cutting kit. In addition to the ratcheting handle a shorter T is included and a hex wrench for installing and removing the dies. That is a very nice and time saving surprise. The fit and finish are perfect, but the most important aspect is the quality of threads cut. So far I've only needed the 1/4-20 tap and die to repair threads on a spool valve and for a custom carburator linkage. This spool was heat treated so it was a reasonable test of the taps hardness and it cut perfect threads. Tap Magic was used as a lubricant fir both the tap and die cuts.