Additional information about ALC3 could not be loaded.
Location: Pa
Nice because it's one piece!
Date:May 23, 2012
I bought this product as a cheap alternative to a trailer. I used it to load my RZT 50inch zero turn mower onto my truck. The ramps were sturdy enough, not the greatest, and attached with two straps which I wish were ratchet straps, but did their job. The ramps instruct you NOT to ride the mower/atv up the ramp, but I did and I weight about 180. So it held me and the mower no problem. I did notice that I slipped near the top of the ramp but I just fed it more gas and it was fine.
The bad side to this product is the ramp is short so it's a very steep angle. I backed my truck up to a hill side so the angle was a little less steep and it worked great.
This ramp is great for zero turns because you don't have to keep your wheels in a track of a narrow two piece ramp.
I did not have my mower deck on when I went up so check to make sure you will have enough clearance so you do not bottow out with the steep angle.
Additional information about Beware could not be loaded.
Buyer Beware
Date:April 23, 2012
Beware if you are looking at this for loading a standard street bike onto a small 4 x 4 ( Ford Ranger here ) it is good for about only one to two uses. First the ramp was too short and the bike bottoms out when loading. Second the cross plates bent with the first use of loading a 600 lbs motorcycle ( note with out rider ) after bringing the bike back off the truck we had to cut off and reweld two the cross plates because they bent so badly. All I can say is that if you are in a pinch and need a throw away ramp then this might work, otherwise I would stay away from it!!!
The ramps work well for lots of things, I use it to load my 700LB ATV, on my pick up and flatbed trailer, Works like a champ, Very light and portable. Good buy
Additional information about nittjd could not be loaded.
Location: State College, PA
Disappointed
Date:May 15, 2011
I purchased in hopes to use for loading garden tractor into back of pickup. Several rungs bent with first use loading 600 lb tractor. Disappointed to say the least.